GCM70

From NewEagleWiki
Revision as of 15:51, 28 August 2023 by Isundin (talk | contribs) (→‎Datasheets)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Overview

The GCM70 is a general-purpose control module. The module has two CAN buses and sports a three-phase motor driver. The eclectic inputs and outputs make this module suitable for a wide variety of general-purpose applications.

The GCM70 is part of a family of rugged, automotive-grade production controllers that use a software development process based on MATLAB/Simulink, known as Raptor-Dev. Raptor-Dev significantly speeds up algorithm development by using automatic code generation. In addition, developers can quickly test application software on their PCs with a built-in onscreen PC simulation.

Datasheets

GCM-5634M-070-1759

Datasheet


Obsolete

GCM-5634M-70-1459

Datasheet

GCM-5634M-070-1559

Datasheet

GCM-5634M-070-1562

Datasheet

GCM-5642A-070-1702

Datasheet

Pins and Crimping

Need to make a harness? Click here to get started.

Want to buy a pre-made harness? Click here to order.

Compiler

GCC PowerPC EABI 4.6.0 SPE

https://wiki.neweagle.net/ProductDocumentation/MotoTron/MotoHawk/gcc-powerpc-eabispe-4_6_0.exe

If opening with Chrome, please copy the download link and paste in the URL bar.

Frequently Asked Questions (FAQ)

Non-Volatile Memory Corruption

Non-Volatile memory can be corrupted during a write if the module is improperly powered off (i.e., removing power from Batt+ (Pin 68)).

Calibrations

In production programs, it is recommended to store all calibrations in Flash memory (available within the "raptor_target_def" block).

Recovery Procedure (Boot Key)

The GCM70 requires a boot key to recover the module. These can be found in our webstore.

To use the boot key to recover the malfunctioned module, please follow the Raptor-Cal MotoHawk Module Recovery steps provided here and below.

Note: The boot key signal (Pin E on the SmartCraft connector) needs to be connected to the SWG4 pin for the GCM70.
Once the boot key is used, the module will default to a CAN baud rate of 250K, so update the Raptor-Cal settings accordingly.


Power Cycle Instructions:

  1. Remove all power to the module by turning off the key-switch and then the power supply. Connect the boot key to the bus.
  2. From Raptor-CAL/Service: Select Program -> click the Recover checkbox -> MotoHawk -> select the RPG file.
  3. Click OK, turn on the power supply, then the key-switch.

For a full list of steps, see the Raptor-CAL FAQ Page.

Bootstrap

The GCM70 can be forced to remain in the firmware bootloader by applying a bootstrap sequence. The bootstrap sequence is:

Pin State for Boot
AN1 High
AN2 High
AN3 High
AN4
AN5
AN6
AN7
AN8
AN9 Low
AN10 Low
AN11 Low

Raptor GCM70 Power Up Process

A product review and development tutorial:

Raptor GCM70 Power Up Process

Difference Between 1459 and 1559 Variants

Pins 39, 40, 41, 59 and 60 have different pull-up resistors.

SPD1 Limit

The frequency speed limit in the SPD1 resource is designed for 10K.