Raptor:H-Bridge Output Block: Difference between revisions
Jump to navigation
Jump to search
Ssienkowski (talk | contribs) (Created page with 'Return to the main Raptor page Return to Input & Output page right|frame|Raptor H-Bridge Output == De…') |
No edit summary |
||
| Line 3: | Line 3: | ||
[[Raptor:Input & Output|Return to Input & Output page]] | [[Raptor:Input & Output|Return to Input & Output page]] | ||
[[File:RaptorHBridgeOutput.jpg|right|frame| | [[File:RaptorHBridgeOutput.jpg|right|frame|Raptor™ H-Bridge Output]] | ||
== Description == | == Description == | ||
Revision as of 15:21, 4 March 2014
Return to the main Raptor page
Description
This block sets the state of the selected H-bridge output. An H-Bridge output is an output which uses 2 pins where either pin can be connected to V+ or V-. This type of output is typically used to drive DC motors which must move in both directions.
Inputs
| Input | Type | Description |
|---|---|---|
| Enable | boolean | Enables the output. When the output is disabled the output pins are not driven high or low. |
| Brake | boolean | Causes the output to brake PWM the output in brake mode when enabled. |
| Duty Cycle | int16 | The duty cycle of the output in 0.01%. For example raw value 500 = 5%. |
| Frequency | uint32 | The frequency of the output in 0.01Hz. For example raw value 40000 = 400Hz. |
Outputs
| Output | Type | Description |
|---|
Parameters
| Parameter | Type | Description |
|---|---|---|
| Hardware Resource | Specifies which input from the hardware is being read. | |
| Driver Type | Specifies the type of driver to be used on the selected output. |
Supported Versions
- Raptor 2013a_0.0.1 and newer