MotoTune Conflict

You may run into issues with MotoTune's CAN messaging conflicting with other CAN communications in your system. It is possible to change the CAN IDs on which MotoTune communicates to avoid this. This article will describe how to do so.

You will need to make changes to both your model and your MotoTune configuration to support the new MotoTune communication CAN IDs.

Model Configuration

1. Disable the MotoTune Protocol in the CAN Definition block
2. Add the MotoTune Custom CAN Protocol Handler block (Idle Triggered)

   RX ID = hex2dec('1A000B02')

   RX ID mask = hex2dec('1F00FFFF')

   TX ID = hex2dec('1A00020B')

• 

  MotoTune Protocol Disabled

• 

  New CAN IDs for the MotoTune Custom CAN Protocol block

MotoTune/MotoServer Configuration

1. Open MotoTune, and configure MotoServer Ports
2. Edit Port Names and Create a Custom CAN Mapping

   TX ID: 436210434 (this is 0x1A000B02, but use decimal here)

   RX ID: 436208139 (this is 0x1A00020B, but use decimal here)

3. Create a new Port configuration
4. After flashing the module, the MotoTune protocol will no longer be available on PCM-1, and will only be available on the new Custom mapping.

• 

  MotoTune context menu

• 

  Edit Names

• 

  Add a port name

• 

  Select 'CAN Custom'

• 

  Enter your name and the appropriate CAN IDs

• 

  Add a port configuration

• 
• 

  Now your custom port is in the ports list!

• 

  Don't forget to select it in the Program dialog box

MotoTune dongle is plugged in but MotoViewer wont open

In order to open up Motoviewer a separate MotoService dongle is required.

MotoTune has stopped working after a Re-install/Update

• Upgrading from 8.13 to 10.0, please uninstall 8.13 first then install 10.0 if you have encountered issues
• When downgrading from 10.0 to 8.13, please uninstall 10.0 first AND MotoLicense Handler before installing 8.13 versions of MotoTune