Raptor:Measurement

Return to the main Raptor page

Return to Data Storage page

Raptor Measurement

Description

The Raptor™ measurement block is used to make values available within the calibration tool. A measurement is a value which typically read only within the calibration tool.

Inputs

Input	Type	Description
value		The measurement value to be shown inside the calibration tool.

Parameters

Parameter	Type	Description
Name	String	This is the name of that will appear in the calibration tool. The name must be a valid C identifier.
Name Source		Chooses whether the name should come from the parameter or input wire name.
Display As		Specifies how to display the value in the calibration tool.
Gain	Number	This controls the scaling used to display the data in the cal tool. display value = (Gain * actual value) + Offset
Offset	Number	This controls the scaling used to display the data in the cal tool. display value = (Gain * actual value) + Offset
Max	Number	Sets the maximum value that can be set to any table data point in the calibration tool.
Min	Number	Sets the minimum value that can be set to any table data point in the calibration tool.
Format	Format String	Sets the display format to use in the calibration tool.
Enumeration Definition	Cell Array of strings or struct array	Provides the mapping of string representation to integer value for the enumeration.
Unit Text	String	Sets the unit text that is displayed in the calibration tool.
Help Text	String	Sets the help text that is displayed in the calibration tool.
Access Level		Sets the access level of this item in the calibration tool.
Function	String	Sets the location where the variable appears in the calibration tool. Use raptor_xcp_function(gcb) to create a function based on the variables location in the model.