GCM-5634M-70-1559: Difference between revisions
(→FAQ) |
|||
| Line 21: | Line 21: | ||
<br/> | <br/> | ||
== FAQ == | == Frequently Asked Questions (FAQ) == | ||
===SPD1 Limit=== | ===SPD1 Limit=== | ||
Latest revision as of 17:48, 31 January 2023
GCM-5634M-70-1559
The GCM-5634M-70-1559 is a general purpose control module. The module has 2 CAN buses and a 3-phase motor driver. The variety of inputs and outputs make this module suitable for a wide range of general purpose applications.
The GCM-5634M-70-1559 is part of a family of rugged, automotive-grade production controllers that use a software development process based on MATLAB/Simulink, known as Raptor-Dev. Raptor-Dev significantly speeds up algorithm development by using automatic code generation. In addition, developers can quickly test application software on their PCs with a built-in onscreen PC simulation.
Datasheet
- GCM-5634M-70-1559
Pins and Crimping
Need to make a harness? Click here to get started.
Want to buy a pre-made harness? Click here to order.
Compiler
GCC PowerPC EABI 4.6.0 SPE
Frequently Asked Questions (FAQ)
SPD1 Limit
The frequency speed limit in the SPD1 resource is designed for 10K.
Recovery Procedure (Boot Key)
The GCM70 requires a Boot Key to recover the module. These can be found on our store page
The use the boot key to recover the malfunctioned module, please follow the Raptor-Cal MotoHawk Module Recovery steps provided: Boot Key Recovery and below.
Notes:
The Boot Key signal (Pin E on the Smartcraft connector) needs to be connected to the SWG4 pin for the GCM70.
Once the bootkey is used, the module will default to a CAN baud rate of 250k, so update the Raptor-Cal settings accordingly.
Power Cycle Instructions:
- Step 1: Remove all power to the module. Make Sure Key switch is off, with the Boot Key connected to the bus.
- Step 2: From Raptor-CAL/Service: Select Program, then the recover check box, MotoHawk, Select the .RPG file.
- Step 3: Click OK, turn on power supply, then key switch.