PWM to Analog Converter: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 7: | Line 7: | ||
=Datasheet= | =Datasheet= | ||
'''[http://www.neweagle.net/support/wiki/docs/PWM_AN_01/D2A_rev2_specification_sheet.pdf PWM to Analog datasheet].''' | |||
=Webstore= | =Webstore= | ||
'''[http://store.neweagle.net/pulse-width-modulator-driver-est-pins.html Webstore: PWM to Analog Converter]''' | |||
Revision as of 17:48, 12 September 2013
Overview
The New Eagle PWM to Analog Converter receives a PWM signal from an ECU, and converts this to a analog output, 0-5 volt output. Single or multiple channels are available. The module is designed to give you the ability to simulate a digital, single potentiometer, or dual potentiometer such as a sensor or pedal interface simulator.
There is an internal override/safety pulse input that you can enable/disable in order to pass through the original signal or the simulated signal. The potentiometer signals are generated using an external low-side drive between 4-10Khz. The incoming signal should be be low side driven because there is an internal 5V pull-up resistor. For more information refer to the datasheet.