GCM-563-48: Difference between revisions
Jump to navigation
Jump to search
| Line 44: | Line 44: | ||
== Webstore == | == Webstore == | ||
'''[http://store.neweagle.net/products-by-category/controllers/general-control | '''[http://store.neweagle.net/products-by-category/controllers-1/general-control-modules.html Webstore: General Control Modules]''' | ||
Revision as of 20:28, 16 December 2013
Overview
These rugged controllers are capable of operating in harsh automotive, marine, and off-highway applications. The onboard floating-point unit and high clock frequency allow software to be executed in short times. The CAN 2.0B datalink ensures interoperability with other vehicle systems.Each controller is available in flash or calibratible versions.
CCM and SIM Modules
The GCM 563-48 0801 and 0802 were also known as the CCM and SIM modules as part of the Fire48 MotoTron Controller Platform
- CCM48 = Command Control Module
- SIM48 = System Integration Module
GCM-563-048-0801 (CCM48) Notes
- Note 1. The ANxM_DGxM pins may be configured as both analog and digital inputs at the same time; the intent is to allow the analog channel to be used for diagnostics of the digital channel. For these shared inputs, the DGxM time constant is 5.1 microseconds.
- Note 2. The 2.585k pull-down analog inputs have a 3k ohm pulldown in parallel with a 16.5k / 2.21k ohm voltage divider pulldown, with the Analog-Digital Converter such that:
- ADC_counts = ( 1024 / 5.00 ) * ( 2.21 / ( 2.21 + 16.50 ) ) * ( V_pin )
- or, 0 <= ADC_counts <= 1023 counts :: 0 <= V_pin <= 42.29 volts
- ADC_counts = ( 1024 / 5.00 ) * ( 2.21 / ( 2.21 + 16.50 ) ) * ( V_pin )
- Note 3. Relationship between ECUP Analog-Digital Converter counts and KEYSW voltage for GCM-0563-048-08xx and HCM-0563-048-08xx:
- ADC_counts_ECUP = ( 1024 / 5.00 ) * ( 2.21 / ( 2.21 + 16.50 ) ) * ( V_keysw - 0.7 volts )
- Please note that the default Main Power Relay block setting of 100 ADC counts corresponds to approximately KEYSW = 4.8 Vdc.
GCM-563-048 Datasheet (36303) Errata
- Page 5 calls out DRVP as pin A23, which shows up as LSO7 in pages 4, 6 and 10
- Page 5 assigns Pin A15 to STOP whereas other pages assign B23 to STOP and A15 to AN13M/DG5M
- CAN1- appears to have quite a few redundant pins – A11, B11 and B21 (Pages 9 & 10)
Current Sense Capability for GCM-563-048
- The GCM-0563-048-0801 (CCM48) module has current sense on H1+ (high side only).
- The GCM-0563-048-0802 (SIM48) module does NOT have current sense (either side).
Here’s the worst case current sense accuracy % for LSD1-6 based on current level.
What is a Fire48 Controller
This is an engineering acronym for the GCM48 and HCM48 families.
Environmental Testing Data
