Extra Resources and Free Software Tools

CCP Master Blocks for MotoHawk

• CCP Master Blocks for MotoHawk® version 1.0.0 Beta 6

• Beta release of the CCP Master Blocks for MotoHawk® supporting MATLAB 6.5.1 through MATLAB R2008a
• Requirements: MotoHawk 2008a or later, .NET 2.0 Framework

MotoTron Other Documents

Programming and Development Wiring Harness

• 112 Quick Programming Harness

• 112 Development Harness

SmartCraft 4 and 6 port Hub Wiring

• JBox Pin Out

• JBox Wiring

• JBox Internal Circuitry

Hard Boot Recovery

• Hard Boot Recovery Procedure for 48 pin Modules

3D CAD Models

• Requirements: 3D model software

• ECM24 3D Model
• ECM48 3D Model
• ECM112 3D Model
• ECM128 3D Model

KAntrak Software

CCDM PC Tool Installer

• CCDM Installer

Free Software Tools

MotoHawk Scanner

The MotoHawk Scanner is a useful tool when you have to work with a module with unknown programming. Instead of guessing the city ID until finding one that works, or using a boot key to reflash the module, you can just use the MotoHawk Scanner to determine which city ID the module is on, and then interact with it in MotoService or MotoTune by that city ID.

To use this tool, make sure the following are completed:

• The Kvaser CAN-to-USB hardware is plugged into your PC, and your PC recognizes the hardware
• The CAN network has a proper termination resistor between the two CAN lines (120 ohms)
• The controller is turned on (battery power and/or key switch) and has proper CAN connection

When using MotoHawk Scanner make sure no other programs are using the CAN bus, for example Mototune or Kvaser Can King. If another program besides MotoHawk scanner is on the bus, the scanner might not work.

• MotoHawk Scanner Tool

DBC File Editor

The File Editor allows the user to modify and create .dbc files.

• DBC File Editor