XCP Slave Blockset

Overview

The MotoHawk XCP Slave blockset can be used in a MotoHawk model to enable connection of a device to a third-party tool to enable calibration, data acquisition, reflash and security by XCP. Examples of third-party tools include INCA, ATI Vision and CANape.

The XCP Slave Blockset was first included in MotoHawk 2015a Beta 4.

The Blockset

Click here for a complete listing of the MotoHawk blocks in the XCP Slave Blockset and their respective help pages.

Features Supported

The MotoHawk XCP Slave blockset supports

• Data Acquisition
• Calibration
• Reflash
• Security
• ASAP2 and SR file generation appropriate for third-party tools

However, not all features are supported on all hardware. STIM (reverse data acquisition STIMulation) is not supported.

Modules Supported

The MotoHawk XCP blockset is supported for calibration, display and reflash for all "MotoCoder" modules released in 2013 and later. These include:

• SECM112 (main): ECM-5644-112 and ECM-5642-112
• SECM70: ECM-5634M-70
• LECM: Large Engine ECM

And many modules going forward.

The MotoHawk XCP blockset is supported for calibration and data acquisition; however, reflash over XCP is not supported for the following modules:

• 24-pin modules
• SECM112 Auxillary Processor (S12G)
• PCM112
• ECM-5554-112
• ECM-S12X-70
• 48-pin modules
• 80-pin modules
• 128-pin modules

MotoTune or MotoService is required to reprogram the above modules.

Licensing

The MotoHawk XCP Slave Blockset is included in MotoHawk and does not require an additional license.