GCM70

Overview

The GCM70 is a general purpose control module. The module has 2 CAN buses, and sports a 3-phase motor driver. The eclectic inputs and outputs make this module suitable for a wide variety of general purpose applications.

The GCM70 is part of a family of rugged, automotive-grade production controllers that use a software development process based on MATLAB/Simulink, known as Raptor-Dev. Raptor-Dev significantly speeds up algorithm development by using automatic code generation. In addition, developers can quickly test application software on their PCs with a built-in onscreen PC simulation.

Variants

GCM-5634M-70-1559

GCM-5634M-70-1562

Datasheets

• GCM-5634M-070-1559

Datasheet

• GCM-5634M-070-1562

Datasheet

• GCM-5642A-070-1702

Datasheet

Obsolete

The GCM-5634M-70-1459 is end of life and is considered obsolete.

GCM-5634M-70-1459

Datasheet

Pins and Crimping

Need to make a harness? Click here to get started.

Want to buy a pre-made harness? Click here to order.

Compiler

GCC PowerPC EABI 4.6.0 SPE

Download Now

If opening with Chrome, please copy the download link and paste in the URL bar.

Frequently Asked Questions (FAQ)

Non-Volatile Memory Corruption

Non-Volatile memory can be corrupted during a write if the module is improperly powered off (ie removing power from Batt+ (Pin 68)).

Calibrations

In production programs, it is recommended to store all calibrations in Flash memory (available within the "raptor_target_def" block).

Recovery Procedure (Boot Key)

The GCM70 requires a Boot Key to recover the module. These can be found on our store page

The use the boot key to recover the malfunctioned module, please follow the Raptor-Cal MotoHawk Module Recovery steps provided: Boot Key Recovery and below.

Notes:
The Boot Key signal (Pin E on the Smartcraft connector) needs to be connected to the SWG4 pin for the GCM70.
Once the bootkey is used, the module will default to a CAN baud rate of 250k, so update the Raptor-Cal settings accordingly.

Power Cycle Instructions:

• Step 1: Remove all power to the module by turning off Key switch and then power supply. Connect the Boot Key to the bus.
• Step 2: From Raptor-CAL/Service: Select Program, then the recover check box, MotoHawk, Select the .RPG file.
• Step 3: Click OK, turn on power supply, then key switch.

For a full list of steps, see the Raptor-CAL FAQ Page

Bootstrap

The GCM70 can be forced to remain in the firmware bootloader by applying a bootstrap sequence. The bootstrap sequence is:

Pin	State for Boot
AN1	High
AN2	High
AN3	High
AN4
AN5
AN6
AN7
AN8
AN9	Low
AN10	Low
AN11	Low

Raptor™ GCM 70 Power Up Process

Raptor™ GCM 70 Power Up Process, a product review and development tutorial.

Difference Between 1459 and 1559 variants

Pins 39, 40, 41, 59, & 60 have different pull-up resistors

SPD1 Limit

The frequency speed limit in the SPD1 resource is designed for 10K.