Connector Crimp and Removal Tools: Difference between revisions
| Line 76: | Line 76: | ||
This is the removal tool for the 1.5MM for the 112 Pin ECM Gel terminals. | This is the removal tool for the 1.5MM for the 112 Pin ECM Gel terminals. | ||
[[Image: | [[Image:TOOL-CON-019.jpg|250px]] | ||
:*'''[http://store.neweagle.net/ProductDetail.jsp?LISTID=80000061-1254790552 Webstore: Terminal Removal Tool-1.5MM MATTE]''' | :*'''[http://store.neweagle.net/ProductDetail.jsp?LISTID=80000061-1254790552 Webstore: Terminal Removal Tool-1.5MM MATTE]''' | ||
Revision as of 22:44, 2 November 2011
Tool-Con-001-00
This tool is used for crimping SmartCraft sockets.
Tool-CON-002
This is the tool used for hand crimping 24 Pin Module connector sockets.
Tool-CON-004
This is the tool used for removing the purple cap in a SmartCraft connector.
Tool-CON-005
This tool is used to remove various terminals, including SmartCraft terminals.
Tool-CON-008
This tool is used to crimp leads for the 48/80/128 pin controllers.
Tool-CON-009
This tool is the extraction tool for the 48/80/128 pin ECUs.
Tool-CON-016
This is the crimping tool for the .63MM Gel 112 sockets.
Tool-CON-016-MATTE
This is the crimping tool for the .63MM Matte 112 sockets.
Tool-CON-017
This is the crimping tool for the 1.5MM Gel 112 sockets.
Tool-CON-17-MATTE
This is the crimping tool for the 1.5MM Matte 112 sockets.
Tool-CON-18
This is the removal tool for the .63MM Gel 112 pin ECM terminals.
Tool-CON-18-MATTE
This is the removal tool for the .63MM Matte 112 pin ECM terminals.
Tool-CON-019
This is the removal tool for the 1.5MM for the 112 Pin ECM Gel terminals.
