Harnesses

From NewEagleWiki
Revision as of 17:29, 29 June 2010 by Anonymous (talk | contribs)
Jump to navigation Jump to search

MotoHawk Harnesses

Boot Cable Harnesses, Connectors, and Keys

Errors in configuration, logic or other electronic control module programming made during application development efforts can cause a temporary loss of CAN communications with the module under development. MotoHawk provides the must-have boot keys and cables to remedy this occurrence. Each designed to match the boot connection requirements of the particular ECM model type. Boot keys provide a signal to the STOP pin of the ECM. Boot cables tie certain analog inputs together to a specific signal level.

Development Harness

Development Harnesses are designed specifically for their respective electronic control module. They provide labeled wiring to all ECM pins: I/O, power, ground, etc. and have 10-pin connectors for module programming with CAN. Development Harnesses also provide standard power, ground, and keyswitch connections. This product is rated for use in harsh industrial and automotive environments and includes a main power relay and a fused power connection.

Pigtail Harness

Pigtail Harnesses provide dedicated labeled wires to all pins (I/O, power, ground, etc.) of the respective electronic control module model. They are indispensable for wiring in prototype development and testing efforts and are rated for use in harsh industrial and automotive environments. Pigtail Harnesses are available in a variety of pre-cut harness wire lengths.

Programming Harness

Programming Harnesses are specifically designed for programming the respective Woodward electronic control module model via CAN connection and 10-pin connector. Use this harness with the appropriate CAN-to-PC cable (Kvaser, etc.) connected from the PC USB


Click Here to learn more about MotoHawk Control Solutions

CANtrak Harnesses

CANtrak Configurable Input Harness

CANtrak Configurable Input Module Harnesses - Development Cable Set

CANtrak Display Power Harness

This pre-assembled power harness for CANtrak consists of a mating connector to plug into the display and 1.5m long flying leads for connection to the vehicle or equipment.

Alternatively, a connector kit is available for customers wishing to manufacture their own wiring harnesses.


Click Here to learn more about Display Solutions