PWM to Analog Converter
Overview
The New Eagle PWM to Analog Converter receives a PWM signal from an ECU, and converts this to a analog output, 0-5 volt output. Three channels are available. The module is designed to give you the ability to simulate a digital, single potentiometer, or dual potentiometer such as a sensor or pedal interface simulator.
There is an internal override/safety pulse input that you can enable/disable in order to pass through the original signal or the simulated signal. The potentiometer signals are generated using an external low-side drive between 4-10Khz. The incoming signal should be be low side driven because there is an internal 5V pull-up resistor. For more information refer to the datasheet.