Raptor-Dev-FAQ
New Eagle > Products Wiki > Raptor Platform > Raptor-Dev > Raptor-Dev FAQ
Software Requirements Questions
Is Rator-Dev compatible with Windows 8?
Raptor-Dev is not currently fully supported in Windows 8.
What tools from the MathWorks are required for using Raptor?
Check out the Raptor Prerequisites
MATLAB 2013b Freezes on Startup
This is a known issue with Matlab that requires the patch below:
Licensing Questions
How do I know if my license is properly installed?
Why do I get a licensing error when I try to do a Raptor-Dev build?
Ensure your USB license dongle is plugged in and your license is up-to-date. Verify this in the New Eagle License Viewer tool by clicking “Update License Online”.
Compiling & Building Questions
What compilers are used with Raptor-Dev?
Each Raptor controller data sheet lists the compiler required for the controller. In general, here is the list of compiler vendors for Raptor targets:
- IAR is for CM3620
- Freescale for the CM0711, CM2115 and CM3626
- GCC for VeeCAN displays
- Hitech for ECM196 Bosch controller
What is an .rpg file?
An .rpg file uses the Raptor Package file format and contains both the software and calibration data generated during a Raptor-Dev build.
Where are build files saved?
Build files are saved in C:\ECU.
What is an .a2l file?
An .a2l file contains calibration signal information. .a2l files are generated during a Raptor-Dev build and can be loaded and merged using Raptor-Cal.
Programming & Calibration Questions
How I program a Raptor-Dev software build onto a Raptor control module?
A separate calibration tool must be used to program Raptor-Dev software builds onto Raptor control modules. Customers can choose to user either Raptor-Cal or any tool that follows the XCP protocol.
How I program a Raptor-Dev software build onto a Raptor display?
Raptor displays are programmed using a USB flash drive. Raptor-Cal can be used to load the software build onto a usb flash drive.