Raptor:CAN Tx Raw
Return to the main Raptor page
Description
This block is used to transmit a message on the CAN bus. The message is transmitted whenever the block is executed. The Raptor CAN Tx Message block can be used to transmit periodic messages and when access to the raw CAN message frame is not necessary.
Each CAN raw tx block has a transmit queue. This queue is used to store messages if the transmit block is executed faster than the messages can be transmitted on the CAN bus. This will typically happen if the tx raw block is located in a for or while loop. If the queue is full when the block executes the oldest tx message will be overwritten.
Inputs
| Input | Type | Description |
|---|---|---|
| extended | boolean | Indicates if the message id is standard (0) or extended (1). |
| ID | uint32 | The message id to transmit. |
| Length | uint8 | The length of the message to transmit. Valid values are 0-8. |
| Data | uint8[8] | The raw data bytes of the message to transmit. This must be a vector of length 8. If the specified length is less than 8, the upper bytes are ignored. |
Outputs
| Output | Type | Description |
|---|
Parameters
| Parameter | Type | Description |
|---|---|---|
| CAN Bus Name | String | The CAN bus to transmit the message on. |
| Queue Size | Number | Specifies the size of the transmit queue. |
Supported Versions
- Raptor 2013a_0.0.1 and newer