XCP Slave Blockset
XCP Slave Blockset
The MotoHawk XCP Slave blockset can be used in a MotoHawk model to enable connection of a device to a 3rd party tool to enable calibration, data aquisition, reflash, and security by XCP. Examples of 3rd party tools include INCA, ATI Vision, and CANape.
The XCP Slave Blockset was first included in MotoHawk 2015a Beta 4.
The Blockset
Click Here for a complete listing of the MotoHawk blocks in the XCP Slave Blockset and their respective help pages.
Features Supported
The MotoHawk XCP Slave blockset supports
- Data Aquisition
- Calibration
- Reflash
- Security
- ASAP2 and SR file generation appropriate for 3rd party tools
However, not all features are supported on all hardware. STIM (reverse data aquisition STIMulation) is not supported.
Modules Supported
The MotoHawk XCP blockset is supported for calibration, display, and reflash for all "MotoCoder" modules released in 2013 and later. These include:
- SECM112 (main): ECM-5644-112 and ECM-5642-112
- SECM70: ECM-5634M-70
- LECM: Large Engine ECM
And many modules going forward.
The MotoHawk XCP blockset is supported for calibration and data aquisition; however, reflash over XCP is not supported for the following modules:
- 24-pin modules
- SECM112 Auxillary Processor (S12G)
- PCM112
- ECM-5554-112
- ECM-S12X-70
- 48-pin modules
- 80-pin modules
- 128-pin modules
MotoTune or MotoService is required to reprogram the above modules.
Licensing
The MotoHawk XCP Slave Blockset is included in MotoHawk and does not require an additional license.