VDO Gauge Blocks

M

MotoHawk: Blocks: Model Info

This block displays the current MotoHawk version and when it was built.

V

MotoHawk: Blocks: VDO Gauge Brightness

This block will set the brightness of the backlight on all of the gauges.

MotoHawk: Blocks: VDO Gauge Interface

This block will enable the EZLink protocol on the selected resource of the module. The EZLink protocol will drive one or more VDO gauges. If "Dynamic Create" is checked, this resource will be created the first time this block is executed.

MotoHawk: Blocks: VDO Gauge LED Alarm Write

This block will update the displayed value of the LED Alarm gauge. Gauge -- the gauge to be updated. Each interval takes approximately 3.8msec.

MotoHawk: Blocks: VDO Gauge Reset

This block resets all gauges on the bus back to their default value.

MotoHawk: Blocks: VDO Gauge Write

This block will update the displayed value of the gauge. Gauge -- the gauge to be updated. Each interval takes approximately 3.8msec.

MotoHawk: Blocks: Version Requirements

This block allows requirements for the MATLAB version and MotoHawk version to be placed into a model.