GCM-5634M-70-1562

From NewEagleWiki
Revision as of 12:31, 7 February 2020 by Isundin (talk | contribs)
Jump to navigation Jump to search

GCM-5634M-70-1562

The GCM-5634M-70-1562 is a general purpose control module. The module has 2 CAN buses. The available inputs and outputs make this module suitable for a wide range of general purpose applications.

The GCM-5634M-70-1562 is part of a family of rugged, automotive-grade production controllers that use a software development process based on MATLAB/Simulink, known as Raptor-Dev. Raptor-Dev significantly speeds up algorithm development by using automatic code generation. In addition, developers can quickly test application software on their PCs with a built-in onscreen PC simulation.

Data Sheet

  • GCM-5634M-70-1562
Datasheet

Pins and Crimping

Need to make a harness? Click here to get started.

Want to buy a pre-made harness? Click here to order.


Compiler

GCC PowerPC EABI 4.6.0 SPE

Download Now


Recovery Procedure (Boot Key)

The GCM70 requires a Boot Key to recover the module. These can be found on our store page

The use the boot key to recover the malfunctioned module, please follow the Raptor-Cal MotoHawk Module Recovery steps provided: Boot Key Recovery and below.

Note: The Boot Key signal (Pin E on the Smartcraft connector) needs to be connected to the SWG4 pin for the GCM70.

Power Cycle Instructions:

  • Step 1: Remove all power to the module. Make Sure Key switch is off, with the Boot Key connected to the bus. Baud rate at 250k.
  • Step 2: From Raptor-CAL/Service: Select Program, then the recover check box, MotoHawk, Select the .RPG file.
  • Step 3: Click OK, turn on power supply, then key switch.

For a full list of steps, see the Raptor-CAL FAQ Page

Other Modules

Back to: Controllers