Raptor:Analog Input

From NewEagleWiki
Revision as of 17:22, 16 December 2016 by MHowlett (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Return to the main Raptor page

Return to Input & Output page

Raptor™ Analog Input

Description

This block reads the value of an analog input. An analog input is typically a voltage input on an input pin to the module. This block outputs the raw analog to digital converter counts. The scaling factor to convert from counts to engineering units may be different for different inputs, sensors or modules. The Full ADC Count indicated on the block represents a guideline for the maximum expected ADC count based on the underlying hardware - values above this threshold may not correspond linearly to those within the range.

Inputs

Input Type Description
None

Outputs

Output Type Description
uint16 Value of input.

Parameters

Parameter Type Description
Hardware Resource Specifies which input from the hardware is being read.
Pull Up/Down Specifies pull up/down resistor for input on modules which support this function.
Range Specifies the range for the input on modules which support this function.