MotoService

FAQs Page
MotoHawk Control Solutions

Introduction

MotoService is a package of software used to distribute the following apps to vendors in one installation file:

MotoUpdate
MotoViewer
MotoServer Runtime
KVASER driver installation

The install may be customized by placing an ECUFiles folder in the same directory as the Setup.exe. The ECUFiles folder will copy the contents of the folders (displays (.dis), TDBDLL (.dll), and Updates(.mfu)) into the target installations disks' ECUFiles folder. It should be noted that it will copy to the local disk only when distributed via a removable drive or zip archive.

The PortInfo.cfg file can be customized to add specific ports to the installation. The PortInfo.cfg file should be placed in the ECUFiles folder in the installation directory. This enables the distributors of MotoService to package their own CD or zip archive for distribution to vendors.

MotoUpdateAuthor is used to generate and maintain MotoUpdate (.mfu) files.

MotoService FAQs

What are the minimum PC system requirements for MotoService?

The official requirments are stated as:

Pentium® III 667 MHz PC
256 MB of RAM
Windows® XP SP2 and Vista or greater

MotoService (which is MotoViewer and MotoUpdate) has been used successfully on 'Windows 7 x64' as well.

How do I create an MotoService install package for my Service Technicians

Download MotoService, unzip that file on your engineering machine, inside the zip it looked like:

Inside 'ecufiles', add 'Programs' and 'TDBDLL', so it looks like:

You can add any srz's or MotoTune dll's that are needed for your customers, you might want to add a 'Displays' folder too, with any MotoTune displays your service technicians will need.

You can edit PortInfo.cfg to add/remove ports (these will be added/removed on the installed machine).

The example above will make it so that your customer has just PCM-1 on the machine after running the installer.

After these steps were complete, move the whole folder to a thumb drive (you might burn to a CD) and then install on new machine, running 'MotoService RELEASE 8.13.7.120.exe' from the thumb drive. Do not zip up the files, simply copy the whole directory out to the thumb drive (or burn to CD). See below:

When installed on a clean machine, you should see that the ECUFiles is replicated in the C:\ECUFiles\ folder required for the tools to connect to the ECU, and only port PCM-1 is available (with the example above).

What is a recommended hardware set-up for production module programming

Set-up a test bench
Dedicate a power supply and PC
Use an anti-static pad
Maintain some type of data base for version control including software and calibrations
Create and Label the ECUs
Pack and ship in an appropriate container