CANTRAK 7200/7210
CANtrak 7200/7210 Display
The CANtrak 7200 and 7210 are a series of intelligent, multi-function displays from Veethree Instruments. The ideal man-machine interface monitors numerous CAN based messages and displays the current status of user defined parameters. With its J1939 or custom CAN capability, the CANtrak offers easy integration into a CAN-based control system of MotoHawk® or 3rd party electronics for virtually any type of on-road or off-road vehicle. The CANtrak display is easily configured by New Eagle. A wide range of mounting kits, wiring harnesses and other accessories are also available.
Platform Benefits
- RS232, J1708/J1587 and CANbus datalink compatible
- Monochrome display
- Front and rear mountable (fitting kits required)
- CE Approved design
- Diagnostics interface to the MotoHawk ECU
- CSA Certified and cold weather operation options
- C based programming
- Easily interchangeable with the KAntrak 2700/2710
CANtrak Hardware Comments
Audible Alarm Output
The 4 khz "audible alarm" is a single tone volume device. In a noisy machine environment the 7210 model has an open collector output. It can be used to drive a relay for an external horn, lights, etc.
Difference between CANtrak 7200 and CANtrak 7210
CANtrak 7200 and CANntrak 7210 differ in temperature rating and the aux output. The CANtrak 7210 has an internal heater for operation in lower temperatures, and is the only version with an output (low side) to pull a relay, light, or alarm.
Applications of the CANtrak
Generic Engine Monitor (GEM) Application for CANtrak
For existing J1939 systems, New Eagle can provide displays that have a generic, J1939-compatible program that should work off-the-shelf. This application shows common parameters (RPM, Oil Pressure, etc..) as well as DM1 faults. You can get an idea of the capability of this application by reading the GEM Manual (Current)
J1587 to J1939 Converter
The CANtrak 7200/7210 hardware has both serial and CAN communication channels. One common application is a converter from J1587 to / from J1939 or other CAN protocol to integrate older (pre CAN) products with newer controls and communications.
We will need a list of messages to convert and protocols (J1939, NMEA2000, GMLAN, ...) to quote this converter. You also get a configurable display as a bonus.
System Monitor
This multi-purpose display can act as a system monitor as well as interact with the actuators through the controller OR change parameters or calibrations within the controller with the press of a button.
Datasheet
Click here to see 7200/7210 Datasheets