Raptor-Dev-INCA-Support

INCA V7.3

Please note that Raptor Dev only supports calibration with INCA. Flashing with INCA is not supported.

Steps to build A2L files for INCA

Please see the A2L File Generation support page: Raptor-Dev-A2L-File-Generation

Initial Setup with INCA V7.3

Open INCA, then create a new database	Inca01.png - create new database
In the top-level folder, add your A2L from the Raptor Build output location (“C:\ECU\a2l” by default)	Inca02.png - Choose A2L file - menu
	Inca03.png - Choose A2L file - file explorer
Press “Cancel” when the prompt asks you to select a hex file	Inca04.png - Choose hex file
Add a Workspace	Inca05.png - Add a workspace
In the workspace, configure the hardware; configured for XCP	Inca06.png - Configure hardware
When prompted, select the project A2L	Inca07.png - Select A2L project
Move Seed ‘n Key DLL from C:\Program Files (x86)\NewEagle\Licensing to C:\ETASData\Security	Inca08.png - Move seed & key DLL
Add the security seed/key DLL to the hardware	Inca09.png - Add seed & key DLL
Change “Check memory pages at initialization” and “Optimized Up/Download” to “Never Check” and “Yes,” respectively	Inca10.png - XCP settings
Initialize the hardware	Inca11.png - Initialize hardware - command
	Inca12.png - Initialize hardware - popup
You should be connected over XCP now	Inca13.png - INCA connected
Add an experiment and open it	Inca14.png - Add & open an experiment
You should now be able to configure the experiment to view signals	Inca15.png - Configure the experiment